POA-LMP113 lamp time

Displays Hour the lamp’s elapsed operating POA-LMP113 lamp time (in hours).

Press Xto enter its sub-menu. Press MENUbutton to turn the POA-LMP113 lamp hour counter to 0

hours.

Warming： 

Remove the lens cap first before powering on.

JNever look into the lens when the POA-LMP113 lamp is on. This can damage your eyes. It is

especially important that children are not allowed to look into the lens.

JTo avoid image sticking, it is not recommended that you project the same still

image for more than 15 minutes.

JFaster on-off-cycles will damage the lamp and reduce lamp life. Wait at least for 7

minutes to turn off the projector after powering on.

1. Press ON / STAND-BYbutton to turn off the projector lamp. You will see a message

“Power Off? Press Power again” appear on the screen.

2. Press ON / STAND-BYbutton again to confirm.

3. The cooling fans continue to operate for cooling cycle and the POA-LMP113 Lamp LED goes out.

When the Power LED begins flashing, the projector has entered standby mode.

If you wish to turn the projector back on, you must wait until the projector has completed

the cooling cycle and has entered standby mode.

Once in standby mode, simply press ON / STAND-BYbutton to restart the projector.

4. Disconnect the power cord from the electrical outlet and the projector.