SP-LAMP-LP9 lamp lifetime  

Indicates how many hours the current SP-LAMP-LP9 lamp has been in use. 

The counter starts at zero hours and counts each hour the lamp is in 

use. After 1,900 hours, the message “Change Lamp” temporarily 

appears on the screen when the projector is turned on. Change 

the bulb when the brightness is no longer acceptable. 

The SP-LAMP-LP9 lamp hour counter in the Status menu counts the number of 

hours the SP-LAMP-LP9 lamp has been in use. After 1,900 hours, the message 

“Change Lamp” temporarily appears on the screen when the projector is turned on. Replace the lamp when the brightness is no 

longer acceptable. You can order new lamp modules from your 

InFocus dealer. See “Accessories” on page 44 for information.

Follow these steps to replace the projection SP-LAMP-LP9 lamp:

1Turn off the projector by unplugging the power cord. 

2Wait 30 minutes to allow the projector to cool thoroughly.

3Use a screwdriver to remove the seven screws on the back of 

the projector (Figure 24).

WARNING: Be extremely careful when removing the SP-LAMP-LP9 lamp module.

In the unlikely event that the SP-LAMP-LP9 bulb ruptures, small glass fragments

may be generated. The lamp module is designed to contain

these fragments, but use caution when removing the SP-LAMP-LP9 lamp module.